Serving North Richland Hills and northeast Tarrant County since 2005
Licensed & InsuredFree EstimatesMon-Fri 7am-6pm
(817) 918-8523 Licensed & Insured
Book a Free Foundation Inspection

Foundation Repair in Keller, TX

North Richland Hills Superior Foundation Repair provides professional foundation repair in Keller, TX. We do slab foundation repair, post-tension slab repair, bell-bottom and steel push pier installation, house leveling, root barriers and foundation drainage, all built to an independent engineer's design. The inspection, floor survey and written estimate are free.

Keller is a newer town than most of its neighbors. It had 13,683 people in 1990, 27,345 by 2000 and 45,776 by 2020. So a big share of the houses here went up after 1990, on post-tension slabs, often two stories tall and on wooded lots. That changes how we repair them.

Free Estimate in Keller

Or call (817) 918-8523

Post-Tension Slab Repair in Keller

Most Keller houses from the 1990s and 2000s sit on post-tension slabs. Steel tendons run through the concrete under tension and do much of the work rebar does in an older slab. A lot of builders left a stamped warning in the garage floor.

You don't core, saw or tunnel under one of these without locating the tendons first. On a 2001 house in Keller, a previous contractor had cored through the slab for a plumbing reroute and nicked a tendon. Curtis caught the patched core during the inspection and flagged it for the engineer before anything else was drilled.

The engineer decides whether any tendon needs re-stressing after a lift. The ASCE Texas Section guideline treats tendon stressing as a repair of its own, done after any leveling and crack injection.

Exterior pier work on a post-tension slab looks a lot like any other slab job from the yard. The difference is in the planning, and in knowing where not to cut.

Heavier Keller Houses, Deeper Piers

A two-story Keller house weighs more than a one-story ranch, and the engineer often wants more than a pressed piling. Our drilled bell-bottom piers are a 12-inch shaft 10 to 12 feet deep, belled to 24 to 30 inches, with four #4 bars and 3,000 PSI concrete, cured 7 days before the lift.

When the load needs deeper bearing, steel push piers go in instead: 2-7/8-inch galvanized pipe in 3-foot sections, typically driven 18 to 35 feet. They run $1,200 to $1,900 per pier, and bell-bottoms run $850 to $1,400.

The ground under Keller is mixed. Near the center of town, the USDA soil survey maps Wilson clay loam, which has a clayey subsoil with high shrink-swell. Elsewhere it shows Silstid loamy fine sand and, on slopes, Birome, Aubrey and Rayex soils.

So two lots in the same subdivision can behave differently, and we never price piers before the survey and the engineer's letter. The pier system follows the house and the soil, not a standard package.

Foundation Repair Projects in Keller, TX

Cross Timbers Trees and Big-Lot Drainage

Keller sits on the western edge of the Eastern Cross Timbers, the old post oak woods, and plenty of lots kept their trees. A big post oak near a corner dries out the clay in a long dry spell, and a 60-mil HDPE root barrier 36 to 48 inches deep cuts its roots off from the slab.

Bigger lots also mean more ground draining toward the house, and pools, patios and long beds can trap water against one wall. We regrade for 6 inches of fall in the first 10 feet and run downspouts in solid pipe to a pop-up emitter or daylight.

Keller wraps around the north side of Watauga, TX, a smaller and older town on heavier clay, so our crews often work in both during the same week.

What to Expect on a Keller Foundation Job

Curtis does the inspection himself within 2 business days, taking manometer readings in every room on roughly a 10-foot grid. Plan on 45 to 90 minutes for a typical house.

An independent engineer licensed by the Texas Board of Professional Engineers and Land Surveyors writes the repair plan, and we pull the city permit where one is required. Texas811 marks the lines at least 48 hours before we dig, and our crews carry general liability and workers' compensation insurance.

You get the plumbing static test before and after the lift, the final survey and a lifetime transferable warranty on every pier we install.

Keller Foundation Repair Questions

My Keller house was built in the 2000s. Can it need foundation repair?

Yes. Newer slabs sit on the same clay as older ones. Post-tension slabs resist cracking better, but a dry corner or a downspout at the grade beam can still drop one side.

Can you repair a post-tension slab safely?

Yes, with planning. We locate the tendons before anyone cores, saws or tunnels, and the engineer decides whether any tendon needs re-stressing after the lift.

Will my two-story Keller house need bell-bottom piers?

Sometimes. The engineer picks the system from the load and the soil. Pressed pilings work on many houses, and heavier ones may get bell-bottom piers or steel push piers.

Do I need to remove the oak near my house?

Usually not. A root barrier, plus piers if the corner has already dropped, normally does the job. Removing a big tree can let the clay swell back up under that corner.

How long does a Keller foundation repair take?

Pressed piling jobs of 8 to 14 piers take 1 to 2 days. Bell-bottom piers need a 7-day cure before the lift, and steel push pier jobs of 8 to 12 piers take 2 to 3 days.

Book a Free Foundation Inspection in Keller

Call (817) 918-8523. We'll survey the house, check for post-tension tendons and give you a written estimate the same day.